My Keyless How Can I Program The Keyless Entry Remote To My Car?
How can I program the keyless entry remote to my car? - my keyless
I have a '95 Infiniti G20, and bought a keyless remote for a few months earlier. I bought programming instructions, but were unsuccessful. I'm not going to take it to a dealer, because they cost me $ 60 to the programming. Someone knows what to do? How can I get it to work?
2 comments:
Note: A maximum of 4 remote transmitters can be programmed.
Obtain all remote transmitters.
Open the trunk.
Close and lock all doors.
Insert and remove key from the ignition switch more than 6 times in 10 seconds.
All codes of the original remote to be deleted.
Unlock and lock the vehicle with the driver's door lock / latch opening.
Press the LOCK button on the remote the first to be programmed.
First remote is already programmed.
To program the remote control as follows:
Unlock and lock the vehicle with the driver's door lock / latch opening.
Press the LOCK button on the remote control seconds programmed.
Repeat the above procedure to program remaining remote.
To exit the programming mode: driver or front passenger door open.
Check the operation of all remote transmitters programmed.
You must follow the instructions to a T. When replacing a broken remote control, you may have other problems, such as the recipient. You turn the key and, as a certain amount of seconds off. I had a Ford Focus, which was in the same way ...
Post a Comment